Once soldered, you can clean it up a bit with some rubbing alcohol and Q-Tips if it looks gooey. Last, you might have guessed, solder the new cell to the board which the old battery was removed from. Note: Many times batteries come with a plastic label stuck to the outside of it, this can be easily peeled off to reveal the attached board and + - markings on the battery casing, just be careful not to damage connections from battery to board. The poles are the same, and similarly labelled with a + on the left, and a - on the right. Same procedure, two points on either end of the small board attached to the battery cell, however take care to keep the silver ribbons as intact as possible, the board can be damaged since it will be discarded. Also, notice on the battery surface it shows + on the left and - on the right, FYI.Īfter that, you will have to do the same on the new battery, since the Shuffle circuit is not compatible. To do this, desolder the points on either end of the small board where two silver ribbons from the end of the battery cell are connected, don't worry about the condition of these since they're part of the battery and will be discarded. This also means you have to take care not to damage the board. This board has to be reused, so rather than removing the wires, you have to remove the board from the battery. The old battery has an attached small board which is connected to the player via 3 wires. An example of the tools and the battery which is a replacement for an ipod shuffle. as it's still molten and they'll shift out of place if it hasn't hardened.Ĥ & 5. Also, after soldering a point, let the solder cool for 3-5 seconds before wiggling any wires and etc. NOTE: When soldering electronics with irons greater than 15 Watts, minimize extended contact with the board (more than 5 seconds at a time) as it can cause damage. Radio Shack sells several models for under $20. 25-watt for general circuit board work, I use one that switches from 15 to 30-watt. You'll need a pencil-style soldering iron.ģ. To open the case you'll need a plastic prying tool.Ģ.
#Sansa sandisk battery how to#
How to replace a Sansa Clip internal battery.ġ. From one Sansa Clip enthusiast to another, I hope this helps!
0 kommentar(er)
